Archives

Do the clothes really make the man? Try taking a tip from turners and dress up for dust. Wear a jumpsuit and a face shield when you can’t collect sawdust at the source. This is the outfit turners [...]

  These furniture maker’s symbols are an international language. They have been used for generations because they’re easy to make and easy to understand. A board’s working face and edge are [...]

I have a couple tools from which I frequently remove the dust collector hoses. I got tired of getting out my screwdriver and cranking out the adjustment bolt every time. After a bit of [...]

I cut dados for a tight fit. When I make them too tight, I use a jig that I call a Dado Tuner. The sole is 1⁄2” Baltic birch plywood, measuring 41⁄2“ x …

I well remember the day when I couldn’t get a mortise-and-tenon joint to come together no matter how hard I tightened the clamp. I had ignored a fundamental rule: Always make mortises 1/16“ [...]

When used as an undercoat or sealer, brushable epoxy greatly reduces expansion and contraction in wood. Coat all parts prior to assembly and make sure epoxy gets down into the fastener holes. If [...]

Is there any doubt that magnets positively rule? I’ve never welded anything in my life, but found a great woodworking use for something familiar to metalworkers. And it’s no wonder I like them: [...]

I’ve found that my new digital angle gauge is a great tool for setting an accurate angle on a miter gauge. To set the desired angle, first stand the miter gauge on its face on the rip fence’s [...]

While lounging at the pool one afternoon, I had an inspiration. I “borrowed” one of my kids’ floating pool noodles, cut it into sections and used the pieces as universal connectors for vacuum [...]

My sharpening procedures involve a lot of buffing with compound. On one side of my buffer I’ve mounted a hard felt wheel, and on the other a paper wheel shaped to buff concave bevels. To prevent [...]

Over the years, I have often clamped stops on my drill-press fence to register hole locations in workpieces. Unfortunately, I always seemed to lose the stops. Flip stops always seemed like a good [...]

Many of us are familiar with the technique of using a razor blade to scrape away drips from varnish and other film finishes. It’s a great way to level defects, especially if you use a brand-new [...]